How to make Sky Lanterns

Lovely Illustration by Tuhin Paul

We made sky lanterns to celebrate “Diwali”, a festival of lights in India. You can find the step-by-step tutorial here:
Step 1: Make Paper Balloon
The paper balloon is made using rice papers,butter paper, kite paper or tracing paper. Butter paper works best as it has good tensile strength which prevents the paper from tearing and is easy to handle.


While sticking the sides of the butter paper make sure you stick it properly so that the hot air could not escape from it.
Step 2: Making the rim of the balloon
The open end of the balloon is stuck with a bamboo ring to attache the fuel.

Step 3: Making the Fuel
For making the fuel of Sky lantern, you need wax and napkin papers.

Step 4: Attaching the fuel

The wire used must not be very thick otherwise it may increase the weight of the sky lantern, also it should not be very thin otherwise it would melt with the heat.

Make lots of them and launch them together, sky lanterns when launched looks visually stunning. Its a very eco-friendly and beautiful way of celebrating the festival of lights.
You can watch the video of launching Sky lanterns here:

Advertisement

Glowssoms: Tutorial

Retain the Spring and have a bright Summer!!

This is how I tried to retain the spring this summer !!
I found an old tyre tube in my backyard and converted it into a flowery lamp using series lights and paper roses.
These night blossoms make the living area very pleasant and relaxing. One of the many reasons why we always look forward to go home after work.

Cup dé light: Tutorial

We were trying to make some decorative with series lights & paper cups and came up with this.
Paper cups used for coffee, tea or water can be very easily recycled to make an eco-friendly exotic lamp.
I am just loving the ambiance light this lamp creates in our drawing room.

Every point where one layer of the cup flower comes in contact with the other layer is glued.
It takes some time for layers to get stuck with each other, so its better to finish sticking first 2 layers and then adding the 3rd one.
The red dots shown here are the glued points.